PRENERGY, EnergyType, Cname1, Cname2, Cname3, Cname4, Cname5, Cname6
Prints the total energies of a model or the energies of the specified
components.
EnergyType Type of energies to be printed:
ALL | — | All energies are printed: potential, kinetic, artificial hourglass/drill stiffness, contact stabilization energy, and artificial stabilization energy when applicable. This is the default. |
SENE | — | Potential energy. |
KENE | — | Kinetic energy. |
Cname1, Cname2, Cname3,…Component names for energies of the components printout.
If Cname1 is blank, the total energies are
listed.
If Cname1 = ALL, the energies are listed
for all selected components.
If Cname1 is neither blank nor ALL, it is
the name of an existing component. The energies are listed for up to 6 selected
components named in Cname1 to Cname6.
The PRENERGY command prints out either the total
energies of the entire model or the energies of the components depending on
the Cname1 specification.
Only existing components based on elements (defined with the CM command) are supported when component energies are listed.
This command applies to structural elements only.