/TRLCY

/TRLCY, Lab, TLEVEL, N1, N2, NINC
Specifies the level of translucency.

GRAPHICS: Style

Lab

Apply translucency level to the items specified by the following labels:

ELEM	—	Elements. Use `N1`, `N2`, `NINC` fields for element numbers.
AREA	—	Solid model areas. Use `N1`, `N2`, `NINC` fields for area numbers.
VOLU	—	Solid model volumes. Use `N1`, `N2`, `NINC` fields for volume numbers.
ISURF	—	Isosurfaces (surfaces of constant stress, etc., value). Translucency varies with result value, to a maximum of the specified translucency level.
CM	—	Component group. Use `N1` for component name, ignore `N2` and `NINC`.
CURVE	—	Filled areas under curves of line graphs. Use `N1`, `N2`, `NINC` fields for curve numbers.
ZCAP	—	If /TYPE,`WN`,ZCAP is the current display type, then /TRLCY,ZCAP,`TLEVEL` will display the model in window `WN` with the portion of the model in front of the section plane displayed at the translucency level `TLEVEL`.
ON, OFF	—	Sets the specified translucency display on or off. All other fields are ignored.

TLEVEL

Translucency level: 0.0 (opaque) to 1.0 (transparent).

N1, N2, NINC

Used only with labels as noted above. Apply translucency level to Lab items numbered N1 to N2 (defaults to N1) in steps of NINC (defaults to 1). If N1 is blank or ALL, apply specified translucency level to entire selected range. If Lab is CM, use component name for N1 and ignore N2 and NINC. A value of N1 = P allows you to graphically pick elements, areas, and volumes. You can then assign translucency levels to the entities via the picker. The Lab and TLEVEL fields are ignored when translucency is applied by picking.

Command Default

Zero translucency (opaque) level.

Notes

Specifies the level of translucency for various items. Issue /TRLCY,DEFA to reset the default (0) translucency levels. This command is valid only on selected 2-D and 3-D graphics devices; see in the Basic Analysis Guide for more information on applying translucency.

For 2-D devices, ANSYS displays only the visible faces of the items being displayed. The information behind the facing planes is not displayed. Issuing the /SHRINK command will force the hardware to display information behind the translucent items.

This command is valid in any processor.

Menu Paths

Utility Menu>PlotCtrls>Style>Translucency