KLIST, NP1, NP2, NINC, Lab
Lists the defined keypoints or hard points.
NP1, NP2, NINCList keypoints from NP1 to NP2 (defaults
to NP1) in steps of NINC (defaults
to 1). If NP1 = ALL (default), NP2 and NINC are
ignored and all selected keypoints [KSEL] are listed.
If NP1 = P, graphical picking is enabled and all
remaining command fields are ignored (valid only in the GUI). A component
name may also be substituted for NP1 (NP2 and NINC are
ignored).
LabCoordinate listing key:
(blank) | — | List all keypoint information. |
COORD | — | Suppress all but the keypoint coordinates (shown to a higher degree of accuracy than when displayed with all information). |
HPT | — | List only hard point information. |
Lists keypoints in the active display coordinate system [DSYS]. An attribute (TYPE, MAT, REAL, or ESYS) listed as a zero is unassigned; one listed as a positive value indicates that the attribute was assigned with the KATT command (and will not be reset to zero if the mesh is cleared); one listed as a negative value indicates that the attribute was assigned using the attribute pointer [TYPE, MAT, REAL, or ESYS] that was active during meshing (and will be reset to zero if the mesh is cleared).
This command is valid in any processor.