Notes

Specifies a surface load "function" to be used when the SF or SFE command is issued. The function is supplied through an array parameter vector which contains nodal surface load values. Node numbers are implied from the sequential location in the array parameter. For example, a value in location 11 applies to node 11. The element faces are determined from the implied list of nodes when the SF or SFE command is issued. Zero values should be supplied for nodes that have no load. A tapered load value may be applied over the element face. These loads are in addition to any loads that are also specified with the SF or SFE commands. Issue SFFUN (with blank remaining fields) to remove this specification. Issue SFFUN,STATUS to list current settings.

Starting array element numbers must be defined for each array parameter vector. For example, SFFUN,CONV,A(1,1),A(1,2) reads the first and second columns of array A (starting with the first array element of each column) and associates the values with the nodes. Operations continue on successive column array elements until the end of the column. Another example to show the order of the commands:

*dim,nodepres,array,2
nodepres(1)=11,12
/prep7
et,1,42
n,1
n,2,1
n,3,1,1
n,4,,1
e,1,2,3,4
sfe,1,1,pres,1,3
sfelist ! expected answer: 3 at both nodes 1 and 2 
sfedel,all,pres,all
sffun,pres, nodepres(1)
sfe,1,1,pres,1,5
sfelist ! expected answer: 5+11=16 at node 1, 5+12=17 at node 2
fini

SFFUN does not work for tabular boundary conditions.

This command is also valid in PREP7.

Menu Paths